Magnet Nest - Miniature Base Magnet Positioning Tool

A positioning tool designed to help you attach magnets as close to the center of your miniature bases as possible ✧

Compatible with 50mm / 40mm / 32mm / 28mm / 25mm bases.

Each size position uses a 5mm × 2mm magnet, and 5 magnets are included in total.
Simply place your base in the matching slot to easily position the magnet at the center of the underside of the base.

Please note: The included magnets are not pre-glued to the tool, so you can install them with the polarity that matches the magnets you normally use.
Check the orientation you prefer, then secure them to the tool with super glue or a similar adhesive.

We use a single 5mm × 2mm magnet on our 40mm bases, and for standard miniatures it provides enough holding strength for storage on metal surfaces such as cookie tins without any issues 💡

5mm × 2mm magnets for attaching to your bases are also available separately ✧

How to Use

① If there are any raised areas or protrusions in the center of the underside of the base, remove them first to create a flat surface. Place the base upside down in the slot that matches its size.

② Apply adhesive to the area where you want to attach the magnet.

③ Bring the magnet you want to attach close to the underside of the base.

④ The magnet will automatically snap into the centered position by magnetic force. Once the adhesive has cured, you’re done 💡

Compatible Base Sizes
50mm / 40mm / 32mm / 28mm / 25mm

Included Magnets
5mm × 2mm × 5 pcs
(adhesive required)

Tool Size
Approx. 87mm × 87mm × 6mm

※ Super glue or a similar adhesive is required to secure the included magnets to the tool.
※ Holding strength may vary depending on the miniature’s weight, center of gravity, and the metal surface being used.